Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trane Air Duct Cleaning in Fort Worth, TX | Hollis Air Duct Fort Worth
Trane air duct cleaning in Fort Worth runs $450 – $1,100 for a full system on an average single-family home, depending on duct count and access. We’re an independent Trane service provider, not factory affiliated. What separates our work here is the housing stock: one Fort Worth neighborhood has flex duct that tears if you look at it wrong, and the next has 1960s metal trunks with asbestos tape that needs careful hands, not a hard sell. Call (682) 255-2572 for a written quote before any work starts.
Trane Air Duct Cleaning in Fort Worth: What You Should Know First
We’ve cleaned Trane systems across this city long enough to know the equipment half of a job is only part of the picture. The ductwork downstream matters just as much as the air handler upstream, and in Fort Worth that ductwork splits into two very different animals depending on where your house sits. If you’ve got a Trane variable-speed air handler paired with CleanEffects filtration, the system is moving air through a filter that catches particles down to 0.1 microns. When that filter loads up with Fort Worth’s oak and ragweed pollen plus fine West Texas dust, airflow drops and the blower works harder to push the same cubic feet per minute. Those particles also coat your duct walls, your supply registers, and your return chase. Since 2004, our crew at Hollis Air Duct Fort Worth has cleaned and inspected these systems across the city, including the older brick ranches east and south where original metal ducts can carry asbestos wrap from the day they were installed. Trane sales & service spans the metro, but this page is about the cleaning side, and what Fort Worth specifically demands of a crew doing that work right.
Key takeaways:
- Full-system Trane duct cleaning in Fort Worth typically falls between $450 and $1,100, quoted in writing before work starts.
- We’re independent: no manufacturer affiliation, no factory parts markup driving the price.
- Older Fort Worth homes need asbestos-aware cleaning methods. Newer flex duct needs a lighter touch. We carry the equipment for both.
- Every job is covered by the 365-Day Done Right Promise: if it fails within a year, we return and make it right at no charge.
Styles & brands we work with
Why Fort Worth Residents Choose Us for Trane Service
Roy Castellanos, who runs our Air Duct Cleaning - Fort Worth operation, learned ventilation fundamentals at Los Angeles Trade-Technical College before spending nearly two decades on Trane systems across this city. He has opened enough Fort Worth return boots to know what a decade of Texas pollen and sheetrock dust looks like packed into a supply trunk. Our crew arrives in uniform, background-checked, and with the price already written down. That written price does not move once we’re inside your home. The 365-Day Done Right Promise backs every job in writing: if the cleaning fails, if a duct we sealed comes loose, if the work does not hold up for a full year, we return at no charge and do it again. That’s The Garrison Standard, the same standard the Garrison Partners family has run on since 2004. We don’t ask you to trust adjectives; we put the commitment on paper.
Common Trane Air Duct Cleaning Problems We Solve in Fort Worth
- Clogged Trane CleanEffects cells from pollen and dust. Fort Worth’s oak and ragweed pollen peaks in spring, and West Texas dust storms push fine particulates through your return plenum straight into that collection cell. When the cell loads up, you lose airflow and your Trane unit runs longer cycles to hold temperature. We pull the cells, clean them per Trane’s service guidance, and verify pressure drop across the cell bank before putting the system back together.
- Kinked or crushed flex duct in new Alliance-area homes. High-efficiency Trane XV20i and XR14 systems in far north Fort Worth often pair with flexible duct that was run aggressively at install. Pencil-thin flex at a trunk takeoff, or a duct kinked behind a chase, strangles airflow and makes the blower sound like it’s breathing through a straw. Our video inspection catches these restrictions, and we handle flex duct repair without tearing out the run if it’s accessible.
- Deteriorating insulation and asbestos tape on 1960s metal ducts. East and south Fort Worth’s brick ranches often still run original galvanized trunks wrapped in asbestos-containing tape. Decades of humid cooling cycles break that tape down. We use HEPA-filtered negative air machines and containment protocols so the cleaning process doesn’t disturb the insulation and send fibers into your breathing air.
- Condensate-line growth backing moisture into ductwork. Fort Worth’s summers are brutal on condensate lines. Biological growth inside the line creates blockages, and water backs up into the drain pan and nearby duct insulation. We clear the line, dry the affected duct interior, and treat the pan with an antimicrobial appropriate for the system.
- Return-side leakage pulling attic air into your Trane system. Older Trane installations in Fort Worth ranches often have return boots that pull from a vented attic. That means 140-degree attic air gets drawn into your cooling stream in August. We seal accessible return joints with mastic and show you the before and after airflow readings.
Trane Service in Fort Worth: What Local Conditions Mean for Your Equipment
Fort Worth’s split housing stock forces a decision on the first visit. In east side neighborhoods such as Stop Six and Polytechnic, original Trane systems in 1950s-era homes often had their metal ducts wrapped in asbestos-containing tape at installation. That tape has been cycling through humidity and temperature swings for sixty or seventy years now, and it’s brittle. Put a high-speed rotating brush against it without containment, and you’re not cleaning a duct; you’re releasing fibers into a home. The containment protocol is almost unheard of in newer suburbs like Saginaw or Aledo, where flex duct and modern returns dominate. But in Fort Worth proper, it’s a regular part of our Fort Worth Dryer Vent Cleaning service. We set negative air pressure with a HEPA-filtered machine, use gentler brush techniques on those runs, and seal accessible joints with mastic when we’re finished. If we see significant deterioration, we tell you plainly: cleaning restores flow, but replacement of the wrap or duct section may be the smarter long-term call. We’ll quote both, in writing, and let you decide.
Trane Models & Products We Service in Fort Worth
We service the Trane systems most common across Fort Worth: the XV20i variable-speed heat pump, the XR14 single-stage unit, Hyperion air handlers, and the CleanEffects air filtration system. For critical components like CleanEffects collection cells, blower motors, and control boards, we default to OEM Trane parts to keep your system operating the way Trane engineered it. For duct sealing materials, mastic, and insulation, we use professional-grade aftermarket products that meet or exceed the original spec, because that’s where the aftermarket genuinely outperforms. What we don’t stock locally, we can have in hand quickly through Fort Worth suppliers, so we’re not tying up your system for a week waiting on a part. We never push replacement when a cleaning or a duct repair restores the system to proper airflow. When replacement is genuinely the better call, we lay out the cost difference between cleaning and replacement and let you make the call with real numbers in front of you.
See the difference
Before
After
Before
After
Before
AfterTrane Service Pricing in Fort Worth
Here’s what to expect, honestly and in writing:
- Full-system duct cleaning (typical 3-4 bedroom Fort Worth home): $450 – $750
- Larger homes, two systems, or heavily soiled older metal ducts: $750 – $1,100
- CleanEffects collection cell cleaning (added to duct service): $95 – $175
- Video inspection with report: Included with full-system cleaning; stand-alone runs $150 – $250
- Asbestos-safe containment protocol (older east/south Fort Worth ranches): Add $150 – $300 depending on run count and access
What drives the price: number of supply and return runs, system count, access difficulty, and whether the home needs containment. The quote you get before we start is the price you pay. That’s not a talking point; it’s how we work. A free estimate takes about 20 minutes on the phone and it’s a real number, not a placeholder. Call (682) 255-2572 and we’ll have a written figure to you before the van rolls.
Serving Fort Worth, TX - Our Local Coverage Area
We’re based in the Fort Worth area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs – Trane Air Duct Cleaning in Fort Worth
Yes, and it’s worth doing at the same time. The CleanEffects collection cell is the first place Fort Worth’s pollen and dust load up, and a clogged cell means your blower is working harder even if the ducts are spotless. We remove the cell, clean it per Trane’s service guidance, and recheck pressure drop. If you only clean the ducts and not the cell, you’ll still feel weak airflow out of your registers. Call (682) 255-2572 and ask us to quote both together; it’s usually less than doing them separately.
Yes, by using negative air pressure, HEPA filtration, and gentler brush techniques. We set up a containment zone, pull air through a HEPA-filtered negative air machine, and clean at lower brush speed so the brittle tape on the exterior of the duct isn’t disturbed from the inside. If the tape is already failing or hanging loose, we’ll tell you before we start; in some cases the right move is to seal or remove the wrap rather than try to clean around it. Either way, you’ll know the options and the cost before any work begins.
It can be, but only when the crew treats flex as fragile. High-efficiency Trane units paired with flex duct in far north Fort Worth often suffer from kinks, sagging runs, and separations at the takeoff collars. Aggressive rotary cleaning will tear the inner liner, and once that liner tears, the duct leaks conditioned air into the attic. We use lower-torque cleaning and first run a video inspection to find any existing kinks or damage. If the flex is already compromised, we repair or replace it rather than clean around it. Our team handles Trane service in Southlake and other northern suburbs regularly, and the flex duct picture is the same whether you’re in Alliance or over in Colleyville.
In Fort Worth’s climate, every 3 to 5 years is realistic for most homes. If you have pets, a home built before 1985, allergies in the house, or you run your Trane system heavily from May through September, lean toward every 3 years. Spring pollen from oak and ragweed and the occasional West Texas dust event push fine particulates through your return before the filter catches them. Homes near new construction can need it sooner. If you’re not sure, our video inspection gives you a clear picture of what’s actually inside your ducts before you spend a dime on cleaning.
Often, yes, but the source matters. In Fort Worth’s humid summers, condensate lines and drain pans breed biological growth that produces that musty smell. When moisture backs up into nearby duct insulation, the smell spreads through the supply vents. We clear the line, dry the affected duct section, and treat the pan. If the duct insulation is too far gone, cleaning alone won’t fix the smell; the insulation has to go. We’ll show you what we find and quote the fix in writing before we touch it. Call (682) 255-2572 and we’ll walk through what you’re smelling and what it takes to fix it.
Service Areas Near Fort Worth
We cover the Fort Worth metro and surrounding communities. You’ll find us working in Fort Worth service area homes from Wedgwood to Alliance, plus Trane service in Mansfield, Euless, Bedford, and Colleyville. If your house is in one of these cities and your Trane system needs duct work, call and we’ll have a written quote before the week is out.
Book Your Trane Service in Fort Worth Today
Clean ducts don’t advertise themselves, but dirty ones will. You’ll smell it in the fall when the heat kicks on, or you’ll feel it in August when your Trane runs all day and still doesn’t hold temperature. We price every job in writing before the work starts, and we stand behind it for a full year. Call (682) 255-2572 for a free estimate. Roy and the crew answer the phone. No voicemail loops.
Written by Roy Castellanos, Owner at Hollis Air Duct Fort Worth, serving Fort Worth since 2004.